Installing Custom Firmware
Writing at 0x00144000... (100 %)Wrote 2223744 bytes (1269044 compressed) at 0x00010000 in 30.5 seconds (effective 583.3 kbit/s)...
Writing at 0x009bc000... (100 %)Wrote 5242880 bytes (706414 compressed) at 0x00910000 in 22.7 seconds (effective 1848.7 kbit/s)...
Hash of data verified.

Leaving...
Hard Resetting...
Done! Flashing is complete!

Showing logs:
[23:08:40] Detected Hardware Version: 1.6.1 and up
[23:08:40] Safe Reset button ENABLED on GPIO 14
[23:08:40] SPIFFS mounted.
[23:08:40] E (510) vfs_fat_sdmmc: sdmmc_card_init failed (0x107).
[23:08:40] SD mount failed with code #263, "ESP_ERR_TIMEOUT"
[23:08:40] fnConfig::load
[23:08:41] Load fnconfig.ini from flash
[23:08:41] fnConfig::load read 601 bytes from config file
[23:08:41] Reading wifi section
[23:08:41] FLASH Config Storage: Enabled
[23:08:41] fnConfig::load read 601 bytes from FLASH config file
[23:08:41] disk UNMOUNT
[23:08:41] FileSystemSPIFFS::filehandler_open /autorun.atr rb
[23:08:41] new FileHandlerLocal
[23:08:41] disk MOUNT
[23:08:41] ATR MOUNT
[23:08:41] FileHandlerLocal::seek
[23:08:41] FileHandlerLocal::read
[23:08:41] mounted ATR: paragraphs=5760, sect_size=128, sect_count=720, disk_size=0
[23:08:41] Creating a default printer using FS_SPIFFS storage and type 1
[23:08:41] SIO SETUP
[23:08:41] Set HSIO baud from 19200 to 67431 (index 6), alt=68209
[23:08:41] Available heap: 4279460
[23:08:41] Setup complete @ 849 (842ms)
[23:08:41] [src/main.cpp:463] main_setup(): Low Heap: 149115
[23:08:41] 
[23:08:41] WiFiManager::start() complete
[23:08:41] WIFI_EVENT_STA_START